Injection molding frame screen

Injection molding frame screen	Injection molding frame screen
Injection molding frame screen	Injection molding frame screen

        The characteristics of this type of injection molding frame screen are as follows:

        1. Mesh number of each layer of the screen is different, accurate and reasonable collocation can make the screening effect more detailed.

        2. High strength steel frame and support bars, as well as moderately tight mesh, form a reliable whole, greatly increasing the flow capacity, strength and service life of the mesh.

        3. The wedge shaped rapid tension device makes the installation of the screen more convenient and saves the downtime for replacement.

        4. The mesh of the lining board divides the mesh into several independent small mesh surfaces to prevent excessive expansion of local damages. Meanwhile, special rubber plugs are equipped to repair the damages, which can save time and reduce the use cost.

        Mainly used in oil, drilling and other aspects.